|
Post by Rick Price on Jan 13, 2006 16:44:18 GMT -5
If you are having trouble installing VoiceDial 2.1 WM5 SP on your Treo 700W. Install the Voices & VoiceDial seperate.
|
|
|
Post by Joe G on Jan 26, 2006 22:14:16 GMT -5
The programs install for me but when I try to run I get the message: The file "voicedial" cannot be opened. Either it is not signed with a trusted certficate, or one of its components cannot be found. You might need to reinstall or restore this file. Please help...very frustrated.
|
|
|
Post by Rick Price on Feb 2, 2006 18:22:02 GMT -5
When the error "Digitally Signed" pops up that means that you have the wrong version of VoiceDial for your device.
|
|
|
Post by Brian Wall on Feb 9, 2006 11:06:34 GMT -5
Just downloaded it from your site (pocketgear) and it appears to the be the 2.0 version (with same error messages) If 2.1 is the correct version for Treo 700w, how do we download it?
|
|
|
Post by Rick Price on Feb 9, 2006 17:43:39 GMT -5
I have found the VoiceDial 2.1 WM5 SP version works better on that device.
|
|
|
Post by Brian Wall on Feb 9, 2006 19:39:03 GMT -5
I found v2.1 for Smartphones and downloaded it and installed it (file by file was required).
It does work, but is not supporting dialing through Bluetooth headset, which the product page states is supported.
The handset microphone picks up the VoiceDial commands and then the BT headset kicks in once the phone starts dialing. But any area noise kills the recognition since it is on the microphone and not the headset.
Is there a configuration option or something that is required for BT headset command support?
Also, the manual still says 2.0 and the About say 2.0 built on May 2005. But the download page says 2.1. How can I verify I purchased/downloaded 2.1?
|
|
|
Post by Rick Price on Feb 17, 2006 18:30:00 GMT -5
You should only have to have the product launched and then you can open a channel from the headset.
This is typical of what is out there, device limitation.
|
|